ELEANOR: The owner says the diesel passed an informal smoke test on the way here. DOUGIE: Who conducted that? ELEANOR: The driver behind him. Through an open window. DOUGIE: Comprehensive feedback. Wrong equipment. ELEANOR: We use the approved smoke meter where an instrumented test is required. First we establish that the opacity test applies and the engine is safe to test. DOUGIE: Then find the manufacturer's smoke plate value. Don't go straight to a familiar default just because you remember where the button is. ELEANOR: The manual uses the manufacturer's plate information first. Where that information is absent, the default depends on first use and, for older vehicles, whether the engine is turbocharged. DOUGIE: Read the actual applicable limit. There is more than one, and “diesel” isn't enough information to choose it. ELEANOR: The current manual also gives a plate-value entry tolerance. Add zero point zero five to the plate value entered into the smoke tester. DOUGIE: So a plate value of zero point one inverse metres is entered as zero point one five. That's the manual's own example. ELEANOR: It prevents incorrect failures caused by manufacturing tolerances. It isn't a discretionary allowance for the owner who looks most disappointed. DOUGIE: Nor something to add again because you like round numbers. Use the current instruction once when entering the plate value. ELEANOR: With satisfactory engine checks and the prescribed preparation complete, follow the meter's prompts for the acceleration test. DOUGIE: After the first acceleration, the manual allows a pass if the reading is sixty per cent or less of the vehicle's limit. ELEANOR: Otherwise, follow the sequence. The mean of the first three readings can establish a pass, or the mean of any three consecutive readings, at or below the limit. There is a maximum of six accelerations in total. DOUGIE: Consecutive matters. You don't choose your three favourites and arrange an awards ceremony. ELEANOR: Best Supporting Reading. The competition would be fierce. DOUGIE: If the first acceleration is significantly higher than the limit, the manual allows you to choose not to complete the test. Six is a maximum, not an instruction to keep going regardless. ELEANOR: And where a diesel particulate filter is fitted, check that there is no visible smoke from the exhaust during the metered check. DOUGIE: A satisfactory meter result doesn't cancel that visual check. We haven't finished merely because the screen has stopped arguing. ELEANOR: On a retest after failure against the manufacturer's plate value, use the same plate value. Don't manufacture a better result by changing the starting point. DOUGIE: Here's what we do: applicable test, safe engine, correct limit and entry, prescribed sequence, then all the required checks. ELEANOR: And remember that genuine hybrids, including mild hybrids with electric and combustion engines, are excluded from this opacity test. Separate lamp requirements still apply. DOUGIE: The chap behind can stand down. His window isn't approved equipment either.