ELEANOR: The customer has sent a photograph of his tyre. It looks splendid. Unfortunately, he has photographed the tyre's good side. DOUGIE: He says there's plenty of tread round the back. ELEANOR: A reassuring sentence about a sofa. Less useful about a tyre. DOUGIE: Here's the actual car. First used in twenty eighteen, five seats, ordinary passenger car. We know which requirement we're applying. One point six millimetres in the primary grooves, across the central three-quarters, round the entire circumference. ELEANOR: All three parts matter. Depth, width and all the way round. A good patch doesn't compensate for a bad patch. DOUGIE: Nor do we take an average. The customer's suggested averaging the tyres as well. He's got a very good spare. ELEANOR: We inspect the tyres fitted to the road wheels. If we notice a defect on the spare, we advise the presenter. DOUGIE: So we turn the road wheel and examine the whole circumference. Proper look, proper measurement where needed. Not one reading where the gauge happens to land. ELEANOR: And make sure we're measuring the primary grooves. The little decorative lines aren't all required to remain the same depth. DOUGIE: The manual distinguishes primary grooves from secondary grooves and sipes. Grooves containing tread wear indicators, or originally cut as deep as those grooves, are primary grooves. ELEANOR: Tread wear indicators themselves don't become the floor we measure from. They are excluded from the tread pattern assessment in the manual's definition. DOUGIE: Now the bit that starts arguments. Either side of that central three-quarters can be bald. ELEANOR: That is the tread-depth rule. It doesn't give the shoulder diplomatic immunity. DOUGIE: We still examine the tyre's condition. Exposed cords, structural damage, all the other applicable checks. Passing the depth requirement isn't passing the whole tyre. ELEANOR: Equally, an unpretty shoulder isn't a depth failure just because we would prefer to see more pattern there. DOUGIE: If this car's primary groove falls below one point six in the required band, anywhere round the circumference, the tread doesn't meet the requirement. The listed category is dangerous. ELEANOR: Don't export that number to every vehicle we test. The manual has different tread requirements for other vehicle groups and ages. DOUGIE: Identify the vehicle. Find the applicable rule. Check the right grooves, over the right width, all the way round. Then consider the other tyre defects separately. ELEANOR: The photograph can stay in the customer's collection. DOUGIE: It was a lovely photograph. ELEANOR: Yes. Excellent coverage of approximately one-eighth of the problem.