
MOTGuard · In the Bay
Play you can feel
Tyres and suspension · 3 min · With Dougie and Eleanor
Listen to this episode
All 40 episodes — choose another
- How this works
- Fog lamps that do not work
- The extra passenger
- Reading the beam
- Before you blame the car
- Headlamp aim
- The LED upgrade
- One lamp, two jobs
- Refuse or decline?
- Stopping a test you started
- Your licence, your name, your record
- Not fit to test today
- The log nobody filled in
- The man reading the notices
- When it goes wrong
- The pads you can't see
- Pipes and hoses
- Cables, rods and levers
- Hydraulics
- Electric parking brakes and four-wheel drive
- Which test for which vehicle
- Tread depth
- Condition, size and type
- Play you can feel
- Compliments to the mechanic
- Ball joints and dust covers
- Anti-roll bars
- Subframes
- Which test applies
- The kit car
- A different engine
- When the book is blank
- Smoke testing
- Before the probe goes in
- The hybrid with a leaking battery
- Hand controls and the road test
- You're done. Now what?
- The quality-control check, including your own
- Calibration, checks and the certificates
- Your risk rating and a site review
Transcript
DOUGIE: The customer says the suspension feels loose. His friend has diagnosed it by watching a video. ELEANOR: Of this car? DOUGIE: A car like this car. Different model. Different noise. Same phone. ELEANOR: Then the phone is our only confirmed common component. DOUGIE: We examine the actual suspension. And before we condemn movement, we establish what is meant to move. ELEANOR: Rubber and synthetic bushes can be designed with a comparatively high degree of compliance. Movement alone is not the whole assessment. DOUGIE: For those bushes, the manual says only reject when we can see serious deterioration of the bonding or flexible material. ELEANOR: That is a specific criterion. A bush doing its designed job is not guilty of looking flexible. DOUGIE: Nor do we call every loose-looking strut top worn. Many MacPherson strut top bushes have significant lateral play when the suspension hangs free. ELEANOR: Reject those when the play is due to wear or maladjustment. The distinction is between movement designed into the system and movement caused by a defect. DOUGIE: Which means the way we support and load it matters. Otherwise we're examining the suspension in a position that hides the wear, or showing us movement we misunderstand. ELEANOR: Follow the manual's examination and jacking method for that suspension layout. Some vehicles need more than one jacking position to remove forces from the joints properly. DOUGIE: Wheel play detectors are the specified way to fully assess the front components. The manual gives the alternative checks where detectors aren't available. We don't replace that with one impressive shove. ELEANOR: Enthusiasm is not an additional piece of approved equipment. DOUGIE: Spring pins and bushes have their own wear guidance. Use a small pinch bar or wheel play detectors. The limits depend on pin diameter. ELEANOR: For example, play exceeding two millimetres on a twelve-millimetre pin is excessive. For a twenty-five-millimetre pin, it's more than three millimetres. Over twenty-five millimetres, it's more than ten per cent of the pin diameter. DOUGIE: Those are spring-pin and bush criteria. Don't carry them across to every ball joint as though we've discovered the universal millimetre. ELEANOR: A suspension pin, bush, joint or bearing that is excessively worn is major. One likely to become detached is dangerous. DOUGIE: So here's what we do. Identify the component and suspension design. Examine it in the appropriate condition. Establish whether the movement comes from wear, and apply the criterion for that component. ELEANOR: Describe the actual defect. Not simply, moves a bit. DOUGIE: The customer's friend has sent another video. ELEANOR: Excellent. Has he found the right car yet?