
MOTGuard · In the Bay
Headlamp aim
Lighting · 3 min · With Dougie and Eleanor
Listen to this episode
All 40 episodes — choose another
- How this works
- Fog lamps that do not work
- The extra passenger
- Reading the beam
- Before you blame the car
- Headlamp aim
- The LED upgrade
- One lamp, two jobs
- Refuse or decline?
- Stopping a test you started
- Your licence, your name, your record
- Not fit to test today
- The log nobody filled in
- The man reading the notices
- When it goes wrong
- The pads you can't see
- Pipes and hoses
- Cables, rods and levers
- Hydraulics
- Electric parking brakes and four-wheel drive
- Which test for which vehicle
- Tread depth
- Condition, size and type
- Play you can feel
- Compliments to the mechanic
- Ball joints and dust covers
- Anti-roll bars
- Subframes
- Which test applies
- The kit car
- A different engine
- When the book is blank
- Smoke testing
- Before the probe goes in
- The hybrid with a leaking battery
- Hand controls and the road test
- You're done. Now what?
- The quality-control check, including your own
- Calibration, checks and the certificates
- Your risk rating and a site review
Transcript
ELEANOR: I have written the headlamp limits on this card. DOUGIE: That's not a card. That's a small bedsheet. ELEANOR: Large enough to conceal a poorly prepared explanation. I've tried it. DOUGIE: Give us one case. European-type dipped beam. Properly set up. Headlamp centre eight hundred millimetres above the ground. ELEANOR: That puts it in the eight hundred and fifty millimetres or less group. The horizontal cut-off must be between the zero point five and two point seven five per cent horizontal lines. DOUGIE: So if the cut-off sits at two per cent, that part of the image is within that vertical band. ELEANOR: That part. We still check the other criteria. A single acceptable measurement is not a complete headlamp result. DOUGIE: The kick-up must be visible unless it has been masked or it is a flat-top pattern. And we check the white-light restriction in the zone the diagram specifies. ELEANOR: Now raise the headlamp centre above eight hundred and fifty millimetres. For this European-type image, the upper part of the permitted band changes. DOUGIE: The horizontal cut-off goes between the one point two five and two point seven five per cent lines. Same type of lamp, different height group. ELEANOR: So the owner's argument that both cars are blue will not help us. DOUGIE: Pity. He has brought photographs. ELEANOR: I shall file them under blue evidence. DOUGIE: The important measurement is the headlamp centre, not the roofline, the bonnet or whether we call it a tall car. ELEANOR: And these are European-type dipped-beam criteria. Do not carry them across to the British American main-beam hot spot or its dipped-beam diagram. DOUGIE: Different image, different part of the image, different criteria. Which is why the diagram belongs beside us, rather than half remembered from the last car. ELEANOR: You don't earn extra marks for assessing it from memory. DOUGIE: I stopped hoping for extra marks when the owner found his blue photographs. ELEANOR: For the learning activity, make two decisions. First choose the correct diagram and height group. Then assess the marked image against every applicable criterion. DOUGIE: And explain what caused the result. Not just good or bad. Was it the cut-off, the hot spot, the specified light zone? Use the terms that belong to that image. ELEANOR: The diagram is the useful resource. A spoken string of percentages is not a substitute for it. DOUGIE: Here's what we do. Identify, measure, select, assess. If we adjust the aim, we still need the resulting image to meet the requirements. ELEANOR: I have reduced the bedsheet to a card. DOUGIE: Good. The car needs testing, not tucking in.